3D printed airbox for Piaggio Maxi engines 125/180cc.
With this box, we can offer you a plug-and-play solution. The rear part of the airbox is replaced, eliminating the need for conversion.
A special intake manifold is included, which can be used with the Malossi/Polini 360° intake manifold plate.
If this is not available, the ‘3D printed plate’ variant is required.
The original cover and seal of the Runner airbox continue to be used.
Our tests have shown that modifying the cover does not improve performance.
Scope of delivery:
- 3D printed airbox
- Screws for assembly
- 2x hose clamps
- Intake manifold
- Filter clip
In our shop, you will also find the matching carburettor from Nibbi, with vacuum and oil connection.
Recommendation from JD-Performance:
Main jet: 132-148
Secondary jet: 42-45
Needle: 4th position from the top
The settings vary depending on the setup and are only a rough guide.
You can also find suitable jet sets in our shop.
Please note! The filter mat is only an example and is not included in the scope of delivery!
We recommend a Malossi or Polini filter mat, which should be moistened with air filter spray to bind fine particles to the filter.